Robotic Drilling of Aluminum Alloy
Performance and Hole Quality
Abstract
This paper presents an experimental approach to evaluate the ability of a six-axis industrial robot to drill aluminum alloy parts. A strategy based on statistical tests has been studied to quantify and predict the relative contribution of cutting parameters on cutting force and shape errors during drilling. This technique is based on the identification of relevant sources of error during high-speed robotic fitting. The machining quality was quantified in terms of dimensional and geometric tolerance, chip formation and evacuation, burr formation, edge build-up, tool wear and surface damage. Statistical analysis of the experimental results reveals a strong dependence between part accuracy and drilling force. An experimental model was developed to represent and predict the cutting force during drilling and an accurate error prediction capability was distinguished. It was found that at high cutting speed and feed rate, the cutting force was the main source of error affecting the accuracy of the machined parts. Verification experiments are performed, and the results reveal that dimensional defects are significantly reduced by a heat treatment effect (90 HRE) and the thrust force decreases with an increase in cutting speed. The recommended cutting speed for robotic drilling is 6000 rpm with a feed rate of 0.15 mm/min. This study provides important technical guidance for improving the robotic drilling of aluminum alloy in practice.
Keywords:
industrial robot, high speed machining, aluminum alloy, design of experiments, desirabilityPublished Online
How to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.
