Microstructure and Corrosion Properties of Austenitic and Duplex Stainless Steel Dissimilar Joints
Abstract
In several applications duplex stainless steels should be joint welded to conventional austenitic stainless steels. In this research LDX 2101 lean duplex stainless steel sheets were welded to conventional 304 austenitic stainless steels, using gas tungsten arc welding. For the welded joints three different welding rods were used: ER 308L, ER 309LSi, and ER 2209. For gas shielding two different shielding gases were used: argon and argon +2% nitrogen. It was found that the nitrogen addition to the shielding gas promoted austenite formation in the weld metal. It was also found Schaeffler-diagram modified by Outokumpu showed a very good estimation to the ferrite content and chemical composition of the weld metal. The ferrite content estimated by the Outokumpu-diagram, showed a close correlation to measured ferrite contents, the highest error was 30%. In case of the chemical composition of the weld metal, the Cr- and Ni-contents were estimated with a maximum of 15% error. In terms of the corrosion resistance, the best pitting corrosion resistance was achieved using the 308L welding rod with argon shielding gas, where the weight loss was 1.6% after the 24 hours immersion test.
Keywords:
duplex stainless steel, dissimilar welded joints, corrosion, prediction of ferrite content, austenitic stainless steelPublished Online
How to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.
