EXPERIMENTAL MEASUREMENTS ON NON-NEWTONIAN AND DRAG REDUCTION FLOWS IN PIPES
Abstract
A laboratory setup was designed for experimental study of non-Newtonian and drag reducing fluid flow in a square cross section pipe. Aqueous solutions of carboxymethyl cellulose (CMC) in water were used as the non-Newtonian fluids while dilute solutions of polyethylene oxide (PEO) in water as the drag reducing fluids. An injection technique was used to overcome the pump degrading effects on the PEO solutions. A turbometer was used for flow rate measurements, a pressure transducer for pressure measurements, Pitot tubes for velocity measurements and Preston tubes for wall shear stress measurements. The performance and calibration of the previous devices are presented in this paper with some results compared with theory.
How to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.



