AGGREGATION TENDENCY OF PARTICULATE FILLERS: DETERMINATION AND CONSEQUENCES
Abstract
The agglomeration tendency of 11 commercial CaCO3 fillers with different particle size and specific surface area was investigated by means of various techniques. Some powder characteristics were measured and also the sedimentation of treated. as well as non-treated fillers were determined in water and toluene. Polypropylene (PP) composites containing 25 vol% filler were homogenized in an internal mixer. Melting and crystallization, as well as tensile properties were determined on compression molded plates. Unambiguous determination of aggregation is difficult. since it depends on interaction and experimental conditions. The extent of aggregation is always determined by the relative magnitude of attractive and separating forces under the given sample preparation and/or testing conditions. Observable aggregation begins at 5-7 m2/ g specific surface area for the studied fillers. but its extent depends also on their particle size distribution and on surface treatment. Composites with a larger number of aggregates possess inferior mechanical properties, however, the effect depends very much on the characteristics measured.
Keywords:
aggregation. polypropylene composites. CaCO3 fillers. characterization of aggregation tendellcyHow to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.



