Investigation of Mg/Al alloy sacrificial anode corrosion with Scanning Electrochemical Microscopy
Abstract
Corrosion of Mg/Al alloy was investigated with the scanning electrochemical microscope (SECM) using a Mg2+ ion selective microelectrode (ISME) as measuring tip. Mg/Al alloys have practical application as sacrificial anodes to prevent the corrosion of various metals susceptible to corrosion. A typical application of such sacrificial anodes is in water boilers. A model (Mg/Al)/Fe target was fabricated using boiler sacrificial anode and high purity iron wires. Corrosion current was measured between the electrically connected galvanic pair, and Mg2+ ion flow rate was calculated with Faraday’s law of electrolysis. However, Mg2+ flow rate could not be calculated with this method while the twometals were left electrically-disconnected. For this reason, fixed height lateral scans and retreating scans were performed above the Mg2+ sample with Mg2+ ion-selective electrodes employed as SECM tips. Mg2+ flow rate was estimated using the concentration profiles obtained with SECM. Relatively high-speed scans were possible with robust, solid contact Mg2+ micropipette electrodes, owing to their low resistance compared to conventional micropipettes of the same size.
Keywords:
Scanning Electrochemical Microscope, SECM, ion-selective microelectrode, ISME, galvanic corrosion, potentiometric tip, solid contactPublished Online
How to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.



