Preparation and characterization of Thioflavin T doped silica nanoparticles
Abstract
Fluorescent silica nanoparticles with diameters of about 300 nm were synthesized based on Stöber´s method, using Thioflavin T as fluorescent co-reagent. The particles were characterized via transmission electron microscopy and fluorimetry measurements. Fluorescence intensity of the sols was ten times higher than that of the ethanol phase solutions of Thioflavin T. Release of dye molecules in stable alcosols was investigated by measuring UV-Vis absorbance spectrum of the supernatant. To try an alternative route, we investigated accumulation of dye molecules in native silica particles. No release effect was detected, and slow accumulation was observed. Water contact angles of the particles were assessed from analyzing the Langmuir films, and were found to be 18\r , very similar to native silica particles. Langmuir-Blodgett films of the particles were deposited on a glass substrate and were examined via UV-Vis spectrophotometry, fluorimetry and scanning electron microscopy. Presence of the film was revealed; the particles formed a continuous, well-packed monolayer.
Keywords:
fluorescent nanoparticles, Thioflavin T, Stöber silica, film balance, wettability, Langmuir-Blodgett filmsHow to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.



