The influence of the interfacial properties of composite catalyst material on the photocatalytic conversion of TiO_2 layer silicates
Abstract
Solid-gas and solid-liquid interfacial properties of titanium dioxide/layer silicate composite sorbents were studied by sorption experiments and the photocatalytic properties were also investigated. The photocatalyst TiO_2 was prepared by the sol-gel method and the sol obtained was used for heterocoagulation of Na-montmorillonite at several different mass ratios, yielding supported photocatalysts of various compositions. The TiO_2 content of the samples ranged from 20 to 75 wt%. The specific surface areas of the samples, determined by nitrogen adsorption, ranged from 120 to 290 m2/g. The catalytic properties of TiO2/montmorillonite composites were tested by photo-oxidation of dichloro acetic acid (DCA). The specific surface area and the porosity exert a major influence on the photocatalytic efficiency through the interfacial layer properties. The rate of photo-oxidation of DCA depends strongly on the surface accessibility of the intermediates and the specific surface area calculated from gas and liquid mixture adsorption data. The conversion data of DCA presented show that the photocatalytic efficiency of TiO2 can depend significantly on the accessibility of different molecules to the TiO2 nanocrysta ls embedded in the layer silicate support in confined space.
Keywords:
adsorption, liquid mixtures, surface area, porosity, photocatalysis, confined spaceHow to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.



